## Effects of Harmonics

Effects of Harmonics: The relationship between line and phase quantities for wye and delta connections as derived earlier are strictly valid only if the source voltage is purely sinusoidal. Such a waveform is an ideal…

Skip to content
##
Effects of Harmonics

##
Reactive Power with Wattmeter

##
Leading Power Factor Load

##
Power Factor by Two Wattmeter Method

##
Three Wattmeter and Two Wattmeter Method

##
Power in Three Phase Circuits

##
Power Measurement in Single Phase Circuit by Wattmeter

##
Unbalanced Three Phase Circuit Analysis

##
Three Phase Balanced Circuit

##
3 Phase Delta Connection

Effects of Harmonics: The relationship between line and phase quantities for wye and delta connections as derived earlier are strictly valid only if the source voltage is purely sinusoidal. Such a waveform is an ideal…

Comments Off on Effects of Harmonics

December 27, 2019

Reactive Power with Wattmeter: We have already seen earlier that the difference between higher reading wattmeter and lower reading wattmeter yields VLIL sin Î¦. So, the total reactive power = âˆš3 VLIL sin Î¦. Reactive…

Comments Off on Reactive Power with Wattmeter

December 27, 2019

Leading Power Factor Load: Suppose the load in Fig. 9.46(a) is capacitive, the wattmeter connected in the leading phase would read less value. In that case, WR will be the lower reading wattmeter, and WY…

Comments Off on Leading Power Factor Load

December 27, 2019

Power Factor by Two Wattmeter Method: When we talk about the power factor in three-phase circuits, it applies only to balanced circuits, since the power factor in a balanced load is the power factor of…

Comments Off on Power Factor by Two Wattmeter Method

December 27, 2019

Three Wattmeter and Two Wattmeter Method: In this method, the three wattmeter are connected in the three lines as shown in Fig. 9.45, i.e. the current coils of the three wattmeter are introduced in the…

Comments Off on Three Wattmeter and Two Wattmeter Method

December 26, 2019

Power in Three Phase Circuits: Measurement of power by a wattmeter in a single phase circuit can be extended to measure Power in Three Phase Circuits. From earlier Section, it is clear that we require…

Comments Off on Power in Three Phase Circuits

December 26, 2019

Power Measurement in Single Phase Circuit by Wattmeter: Wattmeters are generally used to measure power in the circuits. A wattmeter principally consists of two coils, one coil is called the current coil, and the other…

Comments Off on Power Measurement in Single Phase Circuit by Wattmeter

December 26, 2019

Unbalanced Three Phase Circuit Analysis: Types of Unbalanced Loads - An unbalance exists in a circuit when the impedances in one or more phases differ from the impedances of the other phases. In such a…

Comments Off on Unbalanced Three Phase Circuit Analysis

December 26, 2019

Three Phase Balanced Circuit: The analysis of Three Phase Balanced Circuit is presented in this section. It is no way different from the analysis of AC systems in general. The relation between voltages, currents and…

Comments Off on Three Phase Balanced Circuit

December 26, 2019

3 Phase Delta Connection: Delta Connected System - Figure 9.26 shows a balanced three-phase, three-wire, delta-connected system. This arrangement is referred to as mesh connection because it forms a closed circuit. It is also known…

Comments Off on 3 Phase Delta Connection

December 26, 2019